References of "Solid-State Electronics"
     in
Bookmark and Share    
Full Text
Peer Reviewed
See detailFinite element simulation of metal-semiconductor-metal photodetector
Guarino, G.; Donaldson, W. R.; Mikulics, Martin et al

in Solid-State Electronics (2009), 53(10), 1144-1148

Detailed reference viewed: 72 (1 UL)
Full Text
Peer Reviewed
See detailPerformance of unpassivated AlGaN/GaN/SiC HEMTs after short-term electrical bias stress
Bernát, J.; Wolter, M.; Javorka, P. et al

in Solid-State Electronics (2004), 48((2004)), 1825-1828

Performance of unpassivated MOVPE grown AlGaN/GaN/SiC HEMTs under short-term electrical bias stress isreported. Insignificant degradation in DC and RF behaviour of prepared devices after 16 h stress at VD ... [more ▼]

Performance of unpassivated MOVPE grown AlGaN/GaN/SiC HEMTs under short-term electrical bias stress isreported. Insignificant degradation in DC and RF behaviour of prepared devices after 16 h stress at VD ¼ 21 V and VG ¼ 2:5 V is observed. This can be demonstrated by a maximum drain current of 1.03 and 1.01 A/mm and a peak extrinsic transconductance of 233 and 225 mS/mm before and after bias stress, respectively. Consecutive drain voltage sweeps indicates on low current collapse in samples investigated. The RF characteristics show a decrease of the fmax-tof T ratio from 2.23 to 2.15 and the saturated output power density measured at 2 GHz from 3.60 to 3.53 W/mm after the devices were stressed. This result indicates that reliable AlGaN/GaN/SiC HEMTs without passivation can be prepared. However, additional studies are needed to understand if the material structure and/or the device processing is responsible for low current collapse and RF dispersion in these devices. [less ▲]

Detailed reference viewed: 45 (0 UL)
Full Text
Peer Reviewed
See detailEffect of surface passivation on performance of AlGaN/GaN/Si HEMTs
Bernát, J.; Javorka, P.; Fox, A. et al

in Solid-State Electronics (2003), 47((2003)), 2097-2103

Performance of intentionally undoped and doped AlGaN/GaN/Si high electron mobility transistors (HEMTs) before and after passivation with SiO2 and Si3N4 is investigated. Hall effect measurements show ... [more ▼]

Performance of intentionally undoped and doped AlGaN/GaN/Si high electron mobility transistors (HEMTs) before and after passivation with SiO2 and Si3N4 is investigated. Hall effect measurements show higher impact of Si3N4 than SiO2 passivation on the carrier concentration increase in the channel. Improvements in DC performance of HEMTs after passivation with SiO2 and Si3N4 correspond to the changes in sheet carrier concentration. Small signal microwave characterisation shows a decrease (from 18.6 to 9 GHz) and an increase (from 18.4 to 28.8 GHz) of the current gain cut off frequency after SiO2 and Si3N4 passivation, respectively. Similar effect of passivation is found in microwave power changes––only about a half of the power is obtained after SiO2 passivation but more than doubled power results from Si3N4 passivation, measured at 2 GHz. Higher density of interface states for SiO2 than Si3N4 passivation is supposed to be responsible for these effects. However, for an optimal design of GaN-based power devices additional studies related to the interface between a passivation layer and GaN are needed. [less ▲]

Detailed reference viewed: 65 (0 UL)
Full Text
Peer Reviewed
See detailVertical p-MOSFETs with gate oxide deposition before selective epitaxial growth
Moers, J.; Klaes, D.; Tönnesmann, A. et al

in Solid-State Electronics (1999), 43(1999), 529-535

A novel vertical MOSFET concept using selective epitaxial growth by low pressure chemical vapor deposition is proposed and the ®rst p-channel device characteristics measured are described. In contrast to ... [more ▼]

A novel vertical MOSFET concept using selective epitaxial growth by low pressure chemical vapor deposition is proposed and the ®rst p-channel device characteristics measured are described. In contrast to other MOS technologies, the gate oxide is deposited before epitaxy, and therefore it exists before the channel region is grown. Compared to planar layouts, the vertical layout increases the packing density without the use of advanced lithography; the extent of the increase depends on application. Compared to other vertical transistors, this concept reduces overlap capacitance and o ers the possibility of three-dimensional integration. Vertical p channel MOSFETs with a channel length LG down to 130 nm and a gate oxide thickness dox down to 12 nm have been fabricated and yield a transconductance of 100 mS mm-1. [less ▲]

Detailed reference viewed: 45 (0 UL)
Full Text
Peer Reviewed
See detailOptoelectronic D.C. and R.F. behavior of InP/InGaAs Based HEMTs
Marso, Michel UL; Horstmann, M.; Hardtdegen, H. et al

in Solid-State Electronics (1998), 42(1998), 197-200

Detailed reference viewed: 11 (0 UL)
Full Text
Peer Reviewed
See detailElectrical Behaviour of the InP/InGaAs Based MSM-2DEG Diode
Marso, Michel UL; Horstmann, M.; Hardtdegen, H. et al

in Solid-State Electronics (1997), 41(1997), 25-31

Detailed reference viewed: 13 (0 UL)